Meridian
Architectural · Portland, Oregon

Meridian Optics

Six optics. One housing. Every figure read from the file.

Meridian Optics makes one recessed housing and six optics for it, so a ceiling stays a single aperture from the entrance to the back wall.

Every optic is measured on a goniophotometer before it is catalogued, and the measurement is what this site draws. There is no rendering of a light here that is not read from the file the laboratory produced.

The files themselves are on every fixture page, in both LM-63 and EULUMDAT, because the specifier who needs them is going to open DIALux next.

How to read this site

Every luminous figure here is integrated from a photometric file rather than typed into a content block. Across 6 fixtures that is 474 measured candela values, in LM-63 and EULUMDAT.

Illuminance is inverse square with the cosine of incidence, and it is direct only. Nothing on this site counts light bouncing off a wall back onto the floor, so a real room measures higher than these figures. Where the catalogue declares a unified glare rating, it is quoted and never derived: computing UGR properly needs a room inter-reflection model, which is a lighting simulation engine and not a website.

The haze around a beam is a representation. The numbers are not.

The files behind the range

FixtureFileStandardAnglesTest report
Contour 10MO-4210.iesLM-63-2002181 × 1LTL-88410
Contour 24MO-4211.iesLM-63-200291 × 1LTL-88412
Contour 40MO-4212.iesLM-63-200291 × 1LTL-88414
Contour 60MO-4213.iesLM-63-200237 × 1LTL-88416
Wash 85MO-4285.ldtEULUMDAT37 × 1LTL-88418
Lens 110MO-4310.iesLM-63-200237 × 1LTL-88420

Contact

Your regional representative
specify@meridian-optics.example
+1 503 555 0148
Portland, Oregon